Effect of Twist Drill Geometry and Drilling Parameters on Hole Quality in Single-Shot Drilling of CFRP/Al7075-T6 Composite Stack - Archive ouverte HAL Accéder directement au contenu
Article Dans Une Revue Journal of Composites Science Année : 2021

Effect of Twist Drill Geometry and Drilling Parameters on Hole Quality in Single-Shot Drilling of CFRP/Al7075-T6 Composite Stack

Jamaluddin Abdullah
Chim Yi Shen
  • Fonction : Auteur
Reza Mahmoodian
  • Fonction : Auteur
  • PersonId : 1138240
Muhammad Hafiz Hassan
Chim Yi Shen
  • Fonction : Auteur

Résumé

Drilling two different materials in a layer, or stack-up, is being practiced widely in the aerospace industry to minimize critical dimension mismatch and error in the subsequent assembly process, but the compatibility of the drill to compensate the widely differing properties of composite is still a major challenge to the industry. In this paper, the effect of customized twist drill geometry and drilling parameters are being investigated based on the thrust force signature generated during the drilling of CFRP/Al7075-T6. Based on ANOVA, it is found that the maximum thrust force for both CFRP and Al7075-T6 are highly dependent on the feed rate. Through the analysis of maximum thrust force, supported by hole diameter error, hole surface roughness, and chip formation, it is found that the optimum tool parameters selection includes a helix angle of 30°, primary clearance angle of 6°, point angle of 130°, chisel edge angle of 30°, speed of 2600 rev/min and feed rate of 0.05 mm/rev. The optimum parameters obtained in this study are benchmarked against existing industry practice of the capability to produce higher hole quality and efficiency, which is set at 2600 rev/min for speed and 0.1 mm/rev for feed rate.
Fichier principal
Vignette du fichier
2021_Hassan_Journal-Composites-Science.pdf (2.03 Mo) Télécharger le fichier
Origine : Fichiers éditeurs autorisés sur une archive ouverte

Dates et versions

hal-03387802 , version 1 (20-10-2021)

Identifiants

Citer

Gérald Franz, Muhammad Hafiz Hassan, Jamaluddin Abdullah, Chim Yi Shen, Reza Mahmoodian, et al.. Effect of Twist Drill Geometry and Drilling Parameters on Hole Quality in Single-Shot Drilling of CFRP/Al7075-T6 Composite Stack. Journal of Composites Science, 2021, 5 (7), pp.189. ⟨10.3390/jcs5070189⟩. ⟨hal-03387802⟩

Collections

U-PICARDIE LTI
77 Consultations
104 Téléchargements

Altmetric

Partager

Gmail Facebook Twitter LinkedIn More